RED STITCH EDITION
One seam makes the difference
Limited to ten pieces
Nine keys, and only one in your hand.
THE POCKET KNIFE PRINCIPLE
Your keys are stacked between two leather washers and held together by two stainless steel screws, with a white spacer ring between each key. You swing out the one you need – the rest stay flat against the leather.
Depending on how thick your keys are, up to nine will fit. If the stack sits too loose or too tight, add a spacer ring or leave one out. The DEVON measures 4.3 × 8.6 cm and fits in your trouser pocket.
The recess is part of the leather.
A SNUG AIRTAG POCKET
The pocket is formed into the leather by hand, over a mould. It is not a pouch stitched on top and not a glued-in insert – the recess belongs to the leather piece itself. The AirTag sits firmly in it and doesn’t rattle.
You put the AirTag in yourself; it isn’t included.
You put the AirTag in yourself.
FITTING THE AIRTAG
It is pressed into the recess and then sits firmly in the leather.
Our logo is embossed into the underside. You see it when the AirTag pocket faces up.
Set it up once, then forget about it for years.
ASSEMBLY AND MATERIALS
The two leather washers go on the outside, the white spacer rings on the inside, then you stack key and ring in turn. To tighten it you need two flat-head screwdrivers, one for each side. A tip from the workshop: wrap a little tape around the blade – if you slip, the steel won’t hit the leather.
The leather is vegetable-tanned and comes from Tuscany. The screws are stainless steel, the D-ring is matte black and will take your car key, for example. Made by hand in Hamburg, since 2011.
Ten pieces, one red seam.
RED STITCH EDITION
The same construction, a different thread: on the Red Stitch a red contrast seam runs around the AirTag pocket. The same vegetable-tanned leather, the same stainless steel screws, the same matte black D-ring, the same box contents.
We sewed ten of them. You can pick the one you want at the top of this page.
Your most frequent questions about the DEVON key organiser
Up to nine flat keys. How many it is for you depends on their thickness – keys with a plastic head take more room than slim cylinder keys. The car key usually hangs on the D-ring anyway rather than sitting in the leather.
The two leather washers go right on the outside, rough side facing in. Between them you stack key and white spacer ring in turn, finishing with a spacer ring and the outer leather washer.
Tighten until the screws still turn easily but will not come undone by hand. If the stack sits too loose or too tight, add a spacer ring or leave one out – that is how you adjust it without swapping anything.
Two flat-head screwdrivers, one for each side, so you can hold against. The Phillips screwdriver included is for the D-ring.
A tip from the workshop: wrap a little tape around the blade. If you slip, the steel will not hit the leather.
No. The pocket is shaped for an Apple AirTag; you put the AirTag in yourself. It is pressed into the recess from the inside and then sits firmly in the leather.
It can hang on the matte black D-ring if its fixing hole suits. Only flat keys are screwed into the leather itself.
Vegetable-tanned cowhide from Tuscany (Pelle Conciata al Vegetale in Toscana). The fittings are stainless steel, the D-ring matte black. Made by hand in Hamburg.
Wipe it with a dry cloth. If needed, apply a colourless leather care product sparingly.
Vegetable-tanned leather darkens over time and develops a patina. That belongs to it and is not a fault.
The red contrast seam around the AirTag pocket and the run of ten pieces. Structurally it is identical to the black version – same leather, same stainless steel fittings, same D-ring, same box contents.
